Author: Site Editor Publish Time: 2021-08-24 Origin: Site
First confirm whether the two poles of the battery are connected properly. Generally speaking, the remote control battery is under the seat of the custom rc car or at the back of the custom rc car.
Then turn the power switch of the custom rc car to the OFF position. If some custom remote control cars do not have a power switch, you need to switch the switch to the stop position between the remote control and manual, or the stop position between the forward and reverse switches. Because some custom remote control cars only have a forward and backward switch and no stop position, they need to switch to the forward position.
After that, find the charging port, some are round, some are flat, unplug the plug, align the charger plug with the battery end plug, and then plug it tightly, and plug the charger into the power supply.
Generally, it takes 6-10 hours to start charging. When the custom remote control cars are tested and all functions are easy to use, then recharge the battery. The general power of the new battery is about 50%, that is, the battery is charged, but the power is insufficient. Therefore, the new car must be charged in advance. After that, don’t run out of electricity every time you use it. The custom remote control cars can be charged if they drive slowly or become weak. Finally, don’t wait until the custom remote control cars can’t be turned on before recharging.
How to judge that the battery is about to run out? The evaluation standard is that the speed of the car is obviously slower than before. This is because the custom remote control cars are difficult to start due to insufficient energy, the lights are dim, and the sound is low. These phenomena need to be charged in time. Because if you don't charge it right away, over-discharge can easily shorten the battery life. In the future, the charge will be dissatisfied. Some customers report how my car will run out of electricity after playing for a while. This may be due to the exhaustion of electricity.
If the frequency of use is not high, turn off the main power switch after each use, or switch the front and rear switches of the remote control to the middle stop position to reduce power outages, and turn off the remote control switch after each use. If you do not use it for a long time, please unplug the two poles of the battery in the car and take out the battery of the remote control.
If you do not use it for two consecutive months, you must connect the two poles of the battery and recharge it. If you do not use it after fully charged, you should continue to unplug one pole.
Custom remote control cars are recommended to be used frequently, and it is easy to break if not used frequently. Custom remote control cars are mostly plastic parts to avoid collision, rain and exposure. Especially for the charging port, some custom rc car charging ports are installed on the surface of the car body to prevent rain and moisture, and small parts to prevent babies from swallowing. Parents must be by the side of the baby and pay attention to safety.